GETTING STARTED
Preparing the remote control
■ Installing batteries | ■ Using the remote control |
| The remote control transmits a directional infrared ray. |
| Be sure to aim the remote control directly at the remote |
| control sensor on the main unit during operation. |
2 1
3
30 | 30 | Approximately 6 m (20 ft) |
|
+ | + | + |
– | – | – |
1Press the 
part and slide the battery compartment cover off.
2Insert four supplied batteries
(AAA, R03) according to the polarity markings on the inside of the battery compartment.
3Slide the cover back until it snaps into place.
If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the remote control code and program any acquired functions that may have been cleared.
Notes
•Change all of the batteries if you notice conditions such as the operation range of the remote control decreases, the indicator does not flash, or its light or display window become dim.
•Do not use old batteries together with new ones.
•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.
•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
•Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.
Notes
•Do not spill water or other liquids on the remote control.
•Do not drop the remote control.
•Do not leave or store the remote control in the following types of conditions:
–places of high humidity, such as near a bath
–places of high temperatures, such as near a heater or stove
–extremely low temperatures
–dusty places
4
