Prestige 128MH PSTN Router/Hub
13.7.2 Uploading ROM File
The configuration,
Once in debug mode, type [atur3] and wait for your Prestige to respond with “Starting XMODEM upload” to begin uploading the ROM file (uploading procedure varies depending on the software used). After successfully uploading the ROM file, type atgo to restart your Prestige.
If you upload the default ROM file, you will lose all configuration that you had before and the console port will be set to the default of 9600 baud. You will need to change the baud rate of your serial communications software to 9600 before you can connect to the Prestige again.
Menu 24.7.2
To load the ROM file, type "atur3" while in debug mode and wait for "Starting XMODEM upload" before beginning to upload file. Type "atgo" after file has successfully loaded to start RAS. Then change the baud rate to 9600.
Proceeding with the upload will erase the current ROM file.
Do You Which To Proceed:(Y/N)
Figure 13-12. Menu 24.7.2 - System Maintenance - Upload ROM File
13.7.3 Updating Modem Firmware
Commands 3 and 4 allow you to update the firmware for the
System Maintenance |