Prestige 128MH PSTN Router/Hub
The following Table
Table | System Maintenance Menu Diagnostic | |
|
|
|
Fields |
| Description |
|
|
|
Drop WAN Port |
| This command drops the call on a WAN port. Selecting this option brings you to |
|
| the Select WAN Port field to specify the port. |
|
|
|
Reset WAN Port |
| This command resets the specified WAN port. Selecting this option brings you to |
|
| the Select WAN Port field to specify the port. |
|
|
|
Manual Call |
| This option allows you to manually place a call to a remote node. The |
|
| Prestige will show you the trace of what is happening during the call setup |
|
| and PPP negotiation. |
|
| |
Redirect to WAN Port | This command redirects the keyboard to the WAN port. Anything you type will | |
|
| be sent to the WAN device and the device’s response will be shown on your |
|
| screen. Selecting this option brings you to the Select WAN Port field to specify |
|
| the port |
|
| |
Internet Setup Test | This test checks to see if your Internet access configuration is correct. When | |
|
| this option is chosen, your Prestige will call the ISP and perform the PPP |
|
| negotiations. If everything is working properly, you will see an appropriate |
|
| response. Otherwise, note the error message and take the appropriate |
|
| troubleshooting steps. |
|
|
|
Ping Host |
| This diagnostic sends an ICMP echo packet to the remote host and shows |
|
| you the |
|
| the host is reachable via TCP/IP. |
|
|
|
Reboot System |
| This option reboots the system. |
|
|
|
Command Mode |
| This option allows you to enter the command mode. This mode allows you to |
|
| diagnose and test your Prestige using a specified set of commands. |
|
|
|
System Maintenance |