ZyXEL Communications 128MH user manual Remote Node Setup, 2. Menu 11.3- Remote Node TCP/IP Options

Prestige 128MH PSTN Router/Hub

5.1.1 Remote Node Setup

Follow the procedure in Chapter 5 - Remote Node Configuration to configure the protocol- independent parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow the instructions below. If you are configuring your Prestige to receive incoming calls, you also need to set the default dial-in parameters in Menu 13.

Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 5-2.

Step 1. In Menu 11.1, make sure [IP] is among the protocols in the Route field. (The Route field should display Route = IP or Route = IP + IPX.)

Step 2. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and set the value to [Yes]. Press [Enter] to open Menu 11.3 - Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

IP Options:	IPX Options:
Rem IP Addr: 0.0.0.0	Dial-On-Query= N/A
Rem Subnet Mask= 0.0.0.0	Rem LAN Net #= N/A
My WAN Addr= 0.0.0.0	My WAN Net #= N/A
Single User Account= No	Hop Count= N/A
Server IP Addr= N/A	Tick Count= N/A
Metric= 2	W/D Spoofing(min)= N/A
Private= No	SAP/RIP Timeout(min)= N/A
RIP Direction= Both
Version= RIP-2B	Bridge Options:
	Dial-On-Broadcast= N/A
	Ethernet Addr Timeout(min)= N/A

Enter here to CONFIRM or ESC to CANCEL:

Figure 5-2. Menu 11.3- Remote Node TCP/IP Options

5-2 Remote Node TCP/IP Configuration