Point-to-Point Configuration
In some areas, since
S119.1 = 0 - Disable
S119.1 = 1 - Enable
Placing a Call
To initiate a call, configure the TA according to the Bearer Service (or protocol) you want to use.
∙ATBnn - for ISDN data calls.
Placing a call for DSS1
The ATDx command is used for dialing as follows:
ATDx[Yn][Nn]called_party_number[/[Zn]called-party- subaddress/]
x = I (for ISDN data calls), A (for the analog adapter 1), or B (for the analog adapter 2).
Yn specifies the type of number:
∙Y0 - unknown (default if Yn is omitted).
∙Y1 - international number.
∙Y2 - national number.
∙Y3 - network specific number.
∙Y4 - subscriber number.
Nn is the identifier of numbering plan:
Advanced ISDN Call Control 89