ZyXEL Communications omni series user manual Setting S-registers

∙n=1-4- View settings for user profile number (n-1).

∙n=5 - View the factory default settings.

∙n=6 - View the analog adapter’s setting, Phone 1 (non-data).

∙n=7 - View the analog adapter’s setting, Phone 2 (omni.net).

The S-register values may be displayed in either Decimal or Hexadecimal format when using the preceding commands. Bit 3 of S-register 84 sets which numbering system is used for display.

∙ATS84.3=0 - for decimal format.

∙ATS84.3=0 - for Hex format.

To display the value of bit b of S-register r, type:

ATSr.b?

Setting S-registers

In order to change the value in S-register ‘r’ to value ‘n’ use:

ATSr=n (range 0-255)

In order to change the value in a specific bit (b) of S-register r, use:

ATSr.b=n (range 0-1)

In both commands, n is a decimal number in the given range. While the first command modifies all bits in the S-register simultaneously, the second command lets you change bit b without affecting other bits in this S-register. When using ATSr=n, you need to do a conversion to or from the binary number to find out which bits you manipulate.

For example, if you want to set S38 bit 3 to 1 for a specific application, you may either use ATS38.3=1 (simple) or use the following (difficult):

Onote: The values used in the example below differ from the actual values in the S-register and are used for demonstration purposes only.

126 Status Registers and Result Codes