TROUBLESHOOTING AND REPAIR | ||
|
Observe Safety Guidelines detailed in the beginning of this manual.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
PROBLEMS
(SYMPTOMS)
Engine will not start.
POSSIBLE AREAS OF
MISADJUSTMENT(S)
ENGINE PROBLEMS
1.Make sure the ON/OFF switch is in the “ON” position.
2.Check spark plug boot and wire for loose or faulty connection.
3.Make sure that the fuel shutoff valve is in the “ON” position.
4.Make certain that the engine has adequate fuel and oil.
5.Adjust the choke to prevent car- buretor flooding.
6.The recoil starter may not be engaged with the engine. gently hit the blower housing and/or pull the rope to its fully extended position and rapidly wiggle it. Repeat until the clutch engages with the engine shaft and resis- tance is felt.
7.Low oil and engine low oil shut- down protection will not allow unit to start. Light in
RECOMMENDED
COURSE OF ACTION
1.Check the fuel line for breaks or obstructions. Replace the fuel filter. DO NOT RUN THE EN-
GINE WITHOUT AN IN-LINE FUEL FILTER.
2.The spark plug may be faulty. Replace.
3.Service the engine as outlined in the Maintenance Section of this manual.
4.The engine magneto may be
faulty. Consult Briggs & Stratton owner’s manual.
5.The engine may be faulty. Replace.
Return to Section TOC
Return to Master TOC
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed. Call