STARTING
To reduce the risk of electrocution,
keep all connections dry and off the ground. Do not touch plug with wet hands. Do not use if cord is damaged.
1.Verify the
filter screen Filter Screen is in water
inlet of pump. NOTE: Cone side faces out.
2.See How
To Use Wand instructions in this section and select the correct quick connect nozzle for the job to be performed
3.Make sure the ON/OFF switch is in the OFF position.
4.Plug the unit into an
appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances. See the
GROUNDING INSTRUCTION paragraph. ATTENTION: Test
GFCI plug before each use. To test:
GFCI
Plug
d.Press reset button again for use. Do not use if above test fails.
5.Connect water source to pump inlet.
Water
Source
High
Pressure
Hose Hookup
NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.
To reduce the possibility of
contamination always protect against backflow when connected to a potable water system.
6.Connect high pressure hose to pump outlet.
7.If applying a chemical or cleaning solution, see How To Siphon Chemicals/Cleaning Solvents in Operation section of this manual.
8.Turn water source on.
9.Place the
10.Depress trigger on gun to start water flow. NOTE: Stand on a stable surface and grip gun/ wand firmly with both hands. Expect the gun to kick when triggered.
11.Release trigger to stop water flow.
a.Plug GFCI into an appropriate outlet.
b.Press the reset button.
c.Press the test button. Red indicator on reset button should appear.
Risk of injury from spray. Always engage the trigger lock when gun is not in use. Failure to do so could cause accidental spraying.
Trigger Lock Engaged
13- ENG | A17914 |