Porter-Cable A17914-05-10-06, PCE1700 instruction manual Accessories, Repairs

PROBLEM CAUSE CORRECTION

Will not draw	Wand not in low pressure.
chemicals	Chemical filter clogged.
	Chemical screen not in chemical

See How to Use Wand paragraph in the Operation Section.

Clean filter.

Insure end of chemical hose is fully submerged into chemical.

Chemical too thick.

Pressure hose is too long

Dilute chemical. Chemical should be the same consistency as water.

Lengthen water supply hose instead of pressure hose.

	Chemical build up in chemical	Have parts cleaned or replaced
	injector.	by AWSC.
No or low	Worn seal or packing	Have replaced by AWSC.
pressure	Worn or obstructed valves.	Have replaced by AWSC.
(after period
	Worn unloader piston.	Have replaced by AWSC.
of normal
use)	Worn E-Z start valve.	Have replaced by AWSC.
Water	Worn or broken o-ring.	Check and replace.
leaking at
gun/wand	Loose hose connection.	Tighten.
connection
Water	Loose connections.	Tighten.
leaking at	Piston packings worn.	Have replaced by AWSC.
pump
	Worn or broken o-rings.	Have replaced by AWSC.
	Pump head or tubes damaged	Have replaced by AWSC.
	from freezing.

ACCESSORIES

Recommended accessories for use with your pressure washer are available for purchase from your local retailer or authorized service center. If you need assistance in locating any accessory for your tool, please call call 1-888-848-5175 or visit our website www.porter-cable.com.

The use of any other accessory not recommended for use with this tool could be hazardous. Use only accessories

rated equal to or greater than the rating of the pressure washer.

REPAIRS

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by an Authorized Warranty Service Center. Always use identical replacement parts. For the location of the nearest Authorized Warranty Service Center call 1-888-848-5175 or visit our website www.porter-cable.com.

A17914 18- ENG