DeWalt DP2800, A16505 Chemicals and Cleaning Solvents, Starting, To apply chemicals and solvents

Page 11

1.Pull quick-connect coupler back and insert nozzle.

2. Release quick-connect coupler and twist nozzle to make sure it is secure in coupler.

Warning: Flying object could cause risk of serious injury. Ensure nozzle is completely inserted in quick-connect socket and quick- connect snap ring is fully engaged (forward) before squeezing gun trigger.

Chemicals and Cleaning Solvents

Applying chemicals or cleaning solvents is a low-pressure operation.

NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach.

To apply chemicals and solvents

1.

Press chemical hose (S) onto barbed

 

 

fitting located near high pressure hose

 

 

connection of pump as shown.

S

2.

Place the other end of chemical hose

 

 

with filter on it into the container holding

 

 

chemical/cleaning solution.

 

 

NOTE: For every 7 gallons of water

 

 

pumped 1 gallon of chemical/cleaning solution will be used.

 

3.Install low-pressure (black) nozzle into quick connect fitting of spray wand, refer Spray Wand Nozzles.

4.After use of chemicals, place chemical hose into container of clean water and draw clean water through chemical injection system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals will not be covered under warranty.

NOTE: Chemicals and soaps will not siphon when spray wand is in the high-pressure setting.

Starting

Warning: To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual before starting pressure washer.

DANGER: Risk of fluid injection and laceration. When using the high- pressure setting, DO NOT allow the high-pressure spray to come in contact with unprotected skin, eyes, or with any pets or animals. Serious injury will occur.

•Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fit- tings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!

WARNING: Risk of fire, asphyxiation and burning. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.

•Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.

•Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

•DO NOT let hoses come in contact with very hot engine muffler during or immediately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.

CAUTION: Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.

• DO NOT use hot water, use cold water only.

English

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents DP2800 Pressure Washer Laveuse à pression Lavadora a presión CAT 3DX29GSI Pump SpecificationsSpecifications Model Weight Height WidthDeWALT Definitions Safety GuidelinesImportant Safety Instructions What can happen How to prevent it What can happen Risk to Breathing AsphyxiationNever leave wand unattended while unit is running EnglishPressure. Pull starter cord If engine does not start afterTwo pulls, squeeze trigger Gun to relieve pumpBefore each use and while To these very rapidly. AdjustUse a tire pressure gauge To check the tires pressurePressure Washer Assembly Fig For Future USE InstallationChanging Nozzles on Spray Wand Pressure AdjustmentsOperation Spray Wand Nozzles FigTo apply chemicals and solvents Chemicals and Cleaning SolventsStarting Turn the water source on Start-up ProcedureRefer to Chemicals and Cleaning Solvents Connect high-pressure hose C to pump OutletTo Check Oil MaintenanceHow To Change Pump Oil Engine PumpSTORAGE Engine Pump To Clean the Water Inlet FilterTo Remove Tires Repairs Accessories Service InformationLimited Warranty Pressure WasherEnglish Glossary Problem Code Troubleshooting GuideCode Possible cause Troubleshooting CodesPossible Solution Troubleshooting Codes Moteur Caractéristiques techniques de la pompeFiche technique Conserver CES Directives Définitions lignes directrices en Matière de sécuritéDirectives de sécurité importantes CE QUI Peut SE Produire Comment L’ÉVITER CE QUI Peut SE Produire Comment l’éviter Risque D’INJECTION et de lacération suite Au bras Suivre la procédure deDémarrage correcte pour Qui provoquerait ainsi uneAvertissement Risque d’éclatement Français Jusqu’à ce que les boutons soient solidement fixes Assemblage de la laveuse haute pression FigChangement DES Buses SUR LE Tube DE Pulvérisation FonctionnementRéglages de la pression Buses du tube de pulvérisation FigApplication DE Produits Chimiques ET Solvants Produits chimiques et solvants de nettoyageDémarrage Section Produits chimiques et solvants De nettoyage Procédure DE DémarrageRaccorder le tuyau haute pression C à la Sortiede la pompe Chimique ou de nettoyant, se reporter à laMoteur EntretienMéthode DE Vidange DE L’HUILE DE LA Pompe PompeNettoyage du filtre de l’admission d’eau Vérification DU Niveau D’HUILEGlisser le collet hors de l’essieu et retirer le pneu Retrait des pneuRangement Laveuse haute pressionGarantie limitée AccessoiresInformation SUR LES Réparations RéparationsFrançais Glossaire Problème Code Solution ProbableGuide de dépannage Codes de dépannageCodes de dépannage suite Français CAT 3DX29GsI Especificaciones de la bombaEspecificaciones MotorGraves Definiciones Normas de seguridadInstrucciones de seguridad importantes Conserve Estas Instrucciones¿Qué puede suceder? Cómo evitarlo Peligro Riesgo de explosión o incendioPeligro Riesgo DE Inyección DE Líquido y laceración Peligro Riesgo Respiratorio asfixiaSimple Corte Consulte Asegúrese de que laLa carne humana y animal Por ello podría ocasionarPeligro Riesgo de operación insegura Los compresores y el equipo PropiedadObserve el flanco para ver la Nota Los tanques de aireAdvertencia Riesgo de quemadura química Conserve Estas Instrucciones Para Futuras ConsultasAjustes a la presión InstalaciónEnsamblado de la lavadora a presión Fig OperaciónCambio DE LAS Boquillas DE LA Varilla Pulverizadora Boquillas para la varilla pulverizadora FigPara Aplicar Productos Químicos Y Solventes Productos químicos y solventes de limpiezaPuesta en marcha Abra la fuente de agua Procedimiento DE Puesta EN MarchaLimpieza, consulte la sección Productos Químicos y solventes de limpiezaSuelte el disparador para detener el flujo de agua ApagadoMantenimiento MotorPara Controlar EL Aceite BombaLimpieza de las boquillas Para limpiar el filtro de entrada de aguaBomba Para quitar los neumáticosAlmacenamiento Lavadora a presiónPóliza de Garantía AccesoriosInformación DE Mantenimiento ReparacionesGarantía limitada Para Otras Localidades Llame AL 55 5326 GlosarioCódigo Causa posible Guía de detección de problemasCódigos de detección de problemas Problema CódigoOperación Códigos de detección de problemas continuar Español JAN06 Form No. A16505 DP2800 Copyright 2006 DeWALT DeWALT Industrial Tool Co., 701 Joppa Road, Baltimore, MD
Top Page Image Contents