2000W Generator
GENERALGENERATOR
RECOMMENDATIONS MAINTENANCE
Regular maintenance will improve the performance and extend the life of the generator. See any authorized Briggs and Stratton Power Products dealer for service.
The generator’s warranty does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain generator as instructed in this manual.
Some adjustments will need to be made periodically to properly maintain your generator.
All service and adjustments should be made at least once each season. Follow the requirements in the “Maintenance Schedule” chart below in Figure 13.
NOTE: Once a year you should clean or replace the spark plug and replace the air filter. A new spark plug and clean air filter assure proper
Generator maintenance consists of keeping the unit clean and dry. Operate and store the unit in a clean dry environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air slots in the generator must not become clogged with snow, leaves, or any other foreign material.
Check the cleanliness of the generator frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior surface.
NOTE: DO NOT use a garden hose to clean generator. Water can enter the engine fuel system and cause problems. In addition, if water enters the generator through cooling air slots, some of the water will be retained in voids and cracks of the rotor and stator winding insulation. Water and dirt buildup on the generator internal windings will eventually decrease the insulation resistance of these windings.
EMISSION CONTROL
Maintenance, replacement or repair of the emission control devices and systems may be performed by any
Generator Cleaning
Daily or before use, clean accumulated debris from generator. Keep linkage, spring and controls clean. Keep area around and behind muffler free from any combustible debris.
Generator parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.
Figure 13 – Maintenance Schedule
MAINTENANCE SCHEDULE |
|
|
|
|
|
|
|
|
|
|
|
|
FILL IN DATES AS YOU |
|
|
|
| SERVICE DATES |
|
|
|
|
| ||
COMPLETE REGULAR SERVICE |
|
|
|
|
|
|
|
|
| SERVICE DATES | ||
MAINTENANCE TASK | Before |
| Every 10 Hours |
| Every 25 Hours |
| Every 50 Hours |
| Every 100 |
|
|
|
|
|
|
|
|
|
| ||||||
Each Use |
| or 3 Months |
| or Yearly |
| or Yearly |
| Hours or Yearly |
|
|
| |
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
Check oil level | X |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Clean debris | X |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Change engine oil |
|
|
|
|
|
| X¹ |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Service air cleaner |
|
|
|
| X² |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Service spark plug |
|
|
|
|
|
|
|
| X |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Service spark arrester |
|
| X |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Clean cooling system |
|
|
|
|
|
|
|
| X² |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Prepare for storage |
|
| If unit is to remain idle for longer than 30 days. |
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
¹Change oil after the first (5) operating hours and every 50 hours or every year, whichever occurs first, thereafter. Change sooner when operating under dirty or dusty conditions.
²Replace more often under dirty or dusty conditions.
15