Cisco Systems 2.5 manual Utilization %

Chapter 2 Fault Descriptions

				Access Point Faults
Table 2-1 Access Point Faults (continued)
Fault Description	Type	Explanation	Related Setting	Recommended Action
EAP per SSID is	Non-IOS	EAP per SSID has	Manage Fault	Log in to the access point
disabled	and IOS	been disabled on	Settings >	and enable the Network
		the access point.	Security	EAP and Open
		When this fault is	Policies > EAP	authentication per SSID.
			Per SSID
		cleared, the
			Enforced
		following message
		displays: EAP per
		SSID is enabled
Ethernet bandwidth	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
utilization is	and IOS	set for the degraded	Settings >	threshold is set correctly.
Degraded		state has been	Thresholds >	If the threshold is set
(utilization %)		exceeded.	Access Point >
				correctly, review your
			Ethernet Port
		When this fault is		network to determine the
			Utilization
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: Ethernet
		bandwidth
		utilization is OK.
Ethernet bandwidth	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
utilization is	and IOS	set for the	Settings >	threshold is set correctly.
Overloaded		overloaded state	Thresholds >	If the threshold is set
(utilization %)		has been exceeded.	Access Point >
				correctly, review your
			Ethernet Port
		When this fault is		network to determine the
			Utilization
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: Ethernet
		bandwidth
		utilization is OK.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-7