Cisco Systems 2.5 manual Fault Descriptions Switch Faults

Chapter 2 Fault Descriptions

Switch Faults

Table 2-4 Switch Faults (continued)

Fault Description	Explanation	Related Setting	Recommended Action
Port could not agree with	The port could not	This fault is not	Make sure the duplex
other end on duplex mode	agree with the far end	generated based on a	mode on both ends match.
	on port duplex, and is	threshold or policy
	in disagree(3) mode.	violation.
	When this fault has
	been cleared, the
	following message
	displays: Port duplex
	state is OK.
Switch memory	The fault threshold	Manage Fault	Verify that the fault
utilization is Degraded	set for the degraded	Settings >	threshold is set correctly.
(utilization %)	state has been	Thresholds >	If the threshold is set
	exceeded.	Switch > Memory
			correctly, review your
		Utilization
	When this fault has		network to determine the
	been cleared, the		action necessary to clear
	following message		the fault condition.
	displays: Switch
	memory utilization is
	Ok.
Switch memory	The fault threshold	Manage Fault	Verify that the fault
utilization is Overloaded	set for the overloaded	Settings >	threshold is set correctly.
(utilization %)	state has been	Thresholds >	If the threshold is set
	exceeded.	Switch > Memory
			correctly, review your
		Utilization
	When this fault has		network to determine the
	been cleared, the		action necessary to clear
	following message		the fault condition.
	displays: Switch
	memory utilization is
	Ok.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-26