Cisco Systems 2.5 manual Switch Faults

Chapter 2 Fault Descriptions

			Switch Faults
Switch Faults
Table 2-4 Switch Faults
Fault Description	Explanation	Related Setting	Recommended Action
CPU utilization is	The fault threshold	Manage Fault	Verify that the fault
Degraded (utilization %)	set for the degraded	Settings >	threshold is set correctly.
	state has been	Thresholds >	If the threshold is set
	exceeded.	Switch > CPU
			correctly, review your
		Utilization
	When this fault has		network to determine the
	been cleared, the		action necessary to clear
	following message		the fault condition.
	displays: CPU
	utilization is Ok.
CPU utilization is	The fault threshold	Manage Fault	Verify that the fault
Overloaded	set for the overloaded	Settings >	threshold is set correctly.
(utilization %)	state has been	Thresholds >	If the threshold is set
	exceeded.	Switch > CPU
			correctly, review your
		Utilization
	When this fault has		network to determine the
	been cleared, the		action necessary to clear
	following message		the fault condition.
	displays: CPU
	utilization is Ok.
Device was not reachable	The SNMP Agent on	Manage Fault	Make sure that the switch
via SNMP	the switch is down.	Settings >	SNMP agent is active.
	When this fault has	Thresholds >
		Switch > SNMP
	been cleared, the
		Reachable
	following message
	displays: Device was
	reachable via SNMP.
Module is down	The module is down.	Manage Fault	Check the module in the
	When this fault has	Settings >	switch and correct the
		Thresholds >	problem.
	been cleared, the
		Switch > Module
	following message
		Status
	displays: Module is
	up.
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-25