Cisco Systems 2.5 manual Http, Rate %

Chapter 2 Fault Descriptions

				Access Point Faults
Table 2-1 Access Point Faults (continued)
Fault Description	Type	Explanation	Related Setting	Recommended Action
HTTP access is	Non-IOS	HTTP has been	Manage Fault	Log in to the access point
enabled		enabled on the	Settings >	and disable HTTP access.
		access point.	Security
		When this fault is	Policies >
			HTTP Disabled
		cleared, the
		following message
		displays: HTTP
		access is disabled.
HTTP access without	Non-IOS	The	Manage Fault	Log in to the access point
login is enabled		allowBrowseWitho	Settings >	and disable the
		utLogin setting on	Security	allowBrowseWithoutLogi
		the access point is	Policies >	n setting.
		set.	HTTP
		When this fault is	Authentication
		cleared, the
		following message
		displays: HTTP
		access without
		login is disabled.
Non 802.11	IOS	The WLSE	Manage	Use AP Radio Scan (select
interference detected		detected a	Network-Wide	Radio Manager > AP
		non-802.11	Settings >	Radio Scan) to locate the
		interference.	Interference	rogue access point.
			Detection
Packet Error is in	Non-IOS	The fault threshold	Manage Fault	Verify that the fault
Degraded state (error	and IOS	set for the degraded	Settings >	threshold is set correctly.
rate %)		state has been	Thresholds >	If the threshold is set
		exceeded.	Access Point >
				correctly, review your
			RF Port Packet
		When this fault is		network to determine the
			Errors
		cleared, the		action necessary to clear
		following message		the fault condition.
		displays: Packet
		Error is in OK state.
	FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-11