Cisco Systems CF2001P user manual C4004U062AA

Page 10

CF2001P

NEXT

6.Fully pull the toner hopper shutter out toward you. Pulling out the toner hopper shutter allows the toner to begin filling the toner hop- per. Check that all of the toner has emptied out of the toner bottle and into the hopper, which may take a while.

9. Carefully close the yellow toner hopper lid.

C4004U062AA

C4004U066AA

NOTE

Do not tap on the toner bottle while refilling the hopper; otherwise, the toner may spurt out.

10.Fill the magenta, cyan, and black toner in the same way (as described in steps 2 through 9).

NOTE

Be sure to fill the toner hoppers with the cor- rect color of toner.

C4004U063AA

C4004U064AA

7.Push the toner hopper shutter closed until it snaps into place and closes the bottle.

11.After all four toner hoppers are filled, grasp the toner supply door as shown, and then carefully swing the door down to close it.

C4004U067AA

8.Tilt the toner bottle slightly backward, and then pull the opening of the bottle up and toward you to remove it.

C4004U065AB

4004-7715-01	– 9 –

Image 10

Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission