Cisco Systems CF2001P Installing the Manual Holder, Checking the Operation of the Printer

Page 12

CF2001P

NEXT

6. Installing the Manual Holder

1.Insert the tab on the bottom of the manual holder into the slot in the printer as shown in the illustration.

C4004U553AA

2. Insert the tabs on the left and right sides of the manual holder into the corresponding slots in the printer.

7. Checking the Operation of the Printer

NOTE

Before adjusting the printer, be sure to install the interface kit and the control- ler. For more details on their installation, refer to their manuals.

Loading Test Paper

Load test paper specifically for use with X-Rite calibration.

1. Prepare A4-size (or Letter-size) plain paper.

2. Pull out the paper drawer for Tray 1.

C4004U071AA

C4004U554AA

NOTE

If the optional finisher is used, attach the manual holder to the back of the finisher at the position shown, using the same proce- dure described above.

C4004U098AA

3.Press down on the paper-lifting plate until it locks into place.

C4004U072AA

4. Slide the adjustable paper guides to the A4(C) (or Letter(C)) paper size.

C4004U073AA

4004-7715-01

– 11 –

 

Image 12
Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsClear plastic protective sheet is not Packing material therefore, do not removeShaded area, is only attached to Black imaging unitInstalling the Oil-Coating Unit Be sure to install the imaging units in their correct slotsBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission