Cisco Systems CF2001P user manual Setting Up the Converter Setting Up the Selector

Page 14

CF2001P

NEXT

■ Setting Up the Converter (7)	■ Setting Up the Selector (3)
1. Remove the converter from its box.	1. Remove the selector from its box.

C4004U601AA

C4004U556AA

2. Remove the screw at the bottom of the con- verter, and then remove the upper cover.

2.Remove the two screws from the selector, and then remove the upper cover.

C4004U602AA

TERM

NO 1

S2

C4004U557AA

3.Set the TERM switch (S2) to ON as shown in the illustration.

NOTE

•Set the button on the converter to “Nor- mal”.

•In order to reduce the risk of damage to the circuit board due to static electricity, do not touch the circuit board pattern.

•Do not change the setting of any switches other than those specified.

C4004U558AA

3.Affix aluminum tape to the converter as shown in the illustration.

Aluminum tape

C4004U603AA

4004-7715-01	– 13 –

Image 14

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission