Cisco Systems CF2001P Setting DT-105 USA and Canada only, Connecting the Telephone Cables

Page 37

CF2001P

NEXT

Setting DT-105 (USA and Canada only)

NOTE

For details on installing DT-105, refer to the Setup Instructions included with it.

To set the DT-105, follow the instructions below.

To exit the External Panel Controller, refer to step 14 on page 24.

<Connecting the Telephone Cables>

• Connect the telephone cable to the jack marked “LINE” on the data terminal.

NOTE

If the telephone cable is too short, obtain a different cable with modular plugs.

Connection examples

<When the telephone line is only for the data terminal>

4656M007CA

<When the telephone line is for a phone and the data terminal>

4656M008CA

<When the telephone line is only for a fax, phone and data terminal>

4656M009CA

NOTE

For details on connecting the fax, refer to the manual for the fax machine.

4004-7715-01

– 36 –

 

Image 37
Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsPacking material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unitBe sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return