Cisco Systems CF2001P user manual If the cyan test pattern is read correctly, Dialog box

Page 20

CF2001P

NEXT

21.Check that “Read the Pattern of Cyan” dis- appears, and that >> appears beside “Read the Pattern of Magenta”.

		NOTE
		If the cyan test pattern is read correctly,
	C4004P582CA	“Read the Pattern of Cyan” disappears from
	C4004P582CA	the dialog box.
		the dialog box.

22.Prepare the magenta test pattern, and then repeat steps 13 through 21 of the above pro- cedure to read the magenta test pattern with the X-Rite.

NOTE

If the magenta test pattern is read correctly,

C4004P590CA “Read the Pattern of Magenta” disappears from the dialog box.

23.Prepare the yellow test pattern, and then repeat steps 13 through 21 of the above pro- cedure to read the yellow test pattern with the X-Rite.

NOTE

If the yellow test pattern is read correctly,

C4004P591CA “Read the Pattern of Yellow” disappears from the dialog box.

24.Prepare the black test pattern, and then repeat steps 13 through 21 of the above pro- cedure to read the black test pattern with the X-Rite.

C4004P592CA

25.Check that the dialog box appears, set the selector knob on the selector from “B” to “A”, and then click [OK] in the dialog box.

NOTE

Be sure to click [OK] only after the selector knob has been set.

C4004P595CA

A B

C4004U593AA

26.Check that the Tech. Rep. Mode screen is displayed.

C4004P597CA

27. Click [Fin. Time].

4004-7715-01	– 19 –

Image 20

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsClear plastic protective sheet is not Packing material therefore, do not removeShaded area, is only attached to Black imaging unitInstalling the Oil-Coating Unit Be sure to install the imaging units in their correct slotsBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission