Cisco Systems CF2001P user manual Installing the Oil-Coating Unit, Become damaged

Page 7

CF2001P

NEXT

12. Separate the top and bottom halves of the empty imaging unit cover.

NOTE

Since the bottom half of the imaging unit cover will be used when the imaging unit is replaced again, store it in a safe place.

Bottom cover

C4004U055AA

13.Carefully swing the release lever back up to its original position, pushing it in until it locks into place.

NOTE

If the release levers are not correctly posi- tioned, the front door cannot be closed.

C4004U056AA

14.Remove the packing materials from the remaining imaging unit slots, and then install the magenta, cyan, and black imaging units in the same way described in steps 2 through 13.

NOTE

Be sure to install the imaging units in their correct slots.

15. After all four imaging units have been installed, grasp the handle of the front door, and then carefully swing the door closed as shown.

■Installing the Oil-Coating Unit

1. Grasp the upper right-side door as shown, and then carefully open the door completely while making sure to support it.

	NOTE
	Be sure to support the upper right-side door
	while carefully opening it; otherwise, it may
	become damaged.
	C4004U173AA
Metal terminals	NOTE
	Do not touch the metal terminals at the front
	of the fusing unit; otherwise, damage may
	occur due to static electricity.

C4004U149AB

C4004U013AA

4004-7715-01	– 6 –

Image 7

Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsBlack imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached toWhile carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side doorRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return