Cisco Systems CF2001P user manual Click X-Rite Calibration in the Tech. Rep. Mode screen

Page 17

CF2001P

NEXT

C4004P565CA

C4004P597CA

4.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

NOTE

If the basic screen does not appear in the External Panel Controller, turn the printer off. Restart the External Panel Controller, and then turn the printer on again.

5.Click [X-Rite Calibration] in the Tech. Rep. Mode screen.

7.After the test patterns are printed, check that the message appears, and then click the Start key in the External Panel Controller.

C4004P569CA

8.Check that the dialog box appears, set the selector knob to “B”, and then click [OK] in the dialog box.

C4004P570CA

C4004U571AA

6.Check the message that appears, and then click the Start key in the External Panel Con- troller.

Test patterns are printed for the four colors. (Cyan, Magenta, Yellow, Black)

NOTE

C4004P567CA

• Since it may take some time to output the test patterns (about 2 minutes), wait until

Test patterns printing is finished.

• During printing, do not open the front door. If the front door is opened, restart the procedure from step 1.

9.Check that the dialog box appears, and then click [Yes] in the dialog box.

C4004P572CA

10.When the dialog box appears, the auto-cal strip can be read. Prepare the auto-cal strip.

C4004U568AA

C4004P573CA

4004-7715-01	– 16 –

Image 17

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsPacking material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unitBe sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return