Cisco Systems CF2001P user manual Click Left Margin

Page 34

CF2001P

NEXT

5. Click [Left Margin].

C4658P003CA

6.Select the key for the third paper drawer, and then click the Start key in the External Panel Controller.

C4659P002CB

■Checking and Adjusting the Paper Reference Position for AD-14

NOTE

•Perform the procedure below after adjusting the paper reference positions for the paper feed unit and the large-capacity cabinet.

•For details on the installing AD-14, refer to its Setup Instructions.

•To adjust AD-14, follow the instructions below.

•To exit the External Panel Controller, refer to step 14 on page 24.

1.Load A4-size (or Letter size) paper into the paper drawer of the Tray1.

2.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

C4004P565CA

7.Measure the margin from the edge of the paper to the pattern printed in the top-right

	corner of the test page.
a	Standard width (a):
	Standard width (a):

3.0mm ± 1.0 mm (with Fiery X3e installed)

5.0mm ± 1.0 mm (with MicroPress PrintLink 2020m installed)

Click the up and down arrows in the lower- right corner of the screen to enter the differ- ence (in millimeters) between the measured width and the standard width.

C4658U028AA

8.Print another test page and check the paper reference position.

3. Click [Machine Adjust].

C4004P597CA

4. Click [PRT Area].

C4004P588CA

4004-7715-01	– 33 –

Image 34

Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission