Cisco Systems CF2001P user manual Printing the List

Page 24

CF2001P

NEXT

Printing the List

1. Prepare A4-size (or Letter-size) plain paper.

2. Pull out the paper drawer for Tray 1.

C4004U071AA

3.Press down on the paper-lifting plate until it locks into place.

5.Load the prepared A4(L)-size (or Letter(L)- size) plain paper into the paper drawer.

C4004U087AA

6. Slide the adjustable paper guides against the edges of the paper.

NOTE

Check that the adjustable paper guides are pushed up against the edges of the paper.

C4004U072AA

C4004U172AA

4. Slide the adjustable paper guides to the A4(L) (or Letter(L)) paper size.

7.Close the paper drawer.

8.Make sure that the media type selection dial on the drawer is turned to the setting for plain paper.

9.From the control panel, select the size of the paper loaded into Tray 1.

C4004U073AA

C4004U075CA

NOTE

For details on specifying settings, refer to the User Manual.

4004-7715-01

– 23 –

 

Image 24
Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsClear plastic protective sheet is not Packing material therefore, do not removeShaded area, is only attached to Black imaging unitInstalling the Oil-Coating Unit Be sure to install the imaging units in their correct slotsBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission