Cisco Systems CF2001P user manual Dialog box appears if the auto-cal strip was read correctly

Page 18

CF2001P

NEXT

11. Insert the auto-cal strip into the X-Rite.

NOTE

Insert the auto-cal strip after “INSERT CAL

STRIP” appears on the X-Rite display.

C4004U574AA

Reading . . .

31

B D

C A

24

C4004U576AA

Guide

13.Prepare the cyan test pattern, set the X-Rite guide to “10”, and then feed the pattern in direction “1” to read the row represented by “A”.

Align the test pattern with the guide, and insert the pattern into the X-Rite.

*The arrows indicate the direction that the pattern should be fed into the X-Rite.

0.08 0.08 0.06 CALIBRATION OK

MANU

C4004U577AA

C4004U594CA

12. Check that the dialog box appears.

NOTE

The dialog box appears if the auto-cal strip was read correctly.

C4004P575CA

14.Check that the area indicated in the dialog box appears in [OK].

NOTE

The area indicated appears in [OK] if the pattern was read correctly.

C4004P578CA

4004-7715-01	– 17 –

Image 18

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission