Cisco Systems CF2001P user manual Setting Up the Servicing Equipment

Page 13

CF2001P

NEXT

5.Load the prepared A4(C)-size (or Letter(C)- size) plain paper into the paper drawer.

■Setting Up the Servicing Equipment

Set up the equipment in order to print a test pattern and make the necessary adjustments.

NOTE

Do not turn on any equipment until you are instructed to do so.

C4004U074AA	(4)
(5)		(2)
6. Slide the adjustable paper guides against		(8)
the edges of the paper.
NOTE	(3)
Check that the adjustable paper guides are
pushed up against the edges of the paper.	(6)
	(7)	CF2001P
	(1)
C4004U170AA

7.Close the paper drawer.

8.Make sure that the media type selection dial on the drawer is turned to the setting for plain paper.

9.From the control panel, select the size of the test paper loaded into Tray 1.

C4004U075CA NOTE

For details on specifying settings, refer to the User Manual.

(1)Notebook PC

Starts the External Panel Controller for adjustment.

(2)X-Rite (DTP32) Color Tone Tester

(3)Selector

Switches between the Notebook PC and the X-Rite, CF2001P

(4)DTP32 cable

Connects between the X-Rite and the connector A of the selector

(5)RS232 straight cable

Connects between COM1 port of the Notebook PC and the connector C of the selector

(6)RS232 straight cable

Connects between the converter and the connector B of the selector

(7)Converter

Converts the RS422 connector to the RS232 connector

(8)IR Port cable

Connects between the CF2001P and the converter

4004-7715-01	– 12 –

Image 13

Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsPacking material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unitBe sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return