Cisco Systems CF2001P user manual Setting the Telephone Number

Page 42

CF2001P

NEXT

<Setting the Telephone Number>

1. Click [TEL No.] so that it appears in white on a black background.

2. Click the Clear key in the External Panel Controller.

3. Using the keypad in the External Panel

C4656P016CA	Controller, enter the 19-digit telephone
	Controller, enter the 19-digit telephone
	number for the Center.

NOTE

1.Check the screen in the in the External Panel Controller and make sure to enter the data correctly. If an incorrect number is entered, click the Clear key in the External Panel Controller, and then re-enter the data.

2.If the data terminal is connected to an internal switchboard, the time required to access the outside line varies depending on the type of system used. Therefore, enter pause (–) or wait (W) codes for the time required to access the outside line.

•If the access time is 3 seconds or more, enter wait codes by selecting the Energy Saver key.

•If the access time is less than 3 seconds, enter pause codes by selecting the Inter- rupt key.

3.If the data terminal is connected to an internal switchboard where the internal and outside lines are of different systems, enter a pulse code (P) for a rotary line or enter a tone code (T) for a push-button line.

	Key		Function	Display


			Pause	–
	–		Pause	–


			Wait	W
	W		Wait	W

			Pulse	P
	P		Pulse	P

			Tone	T
	T		Tone	T

			Extension key (sharp)	#
	#		Extension key (sharp)	#

			Extension key (asterisk)	*
	*		Extension key (asterisk)	*

4.After the telephone number has been entered, call the Center to inform them of the entered settings.

4.Click [END].

C4656P017CA

4004-7715-01	– 41 –

Image 42

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission