Cisco Systems CF2001P user manual Installing the Units, Installing the Imaging Units

Page 5

CF2001P

NEXT

3. Installing the Units

■Installing the Imaging Units

1. Grasp the handle of the front door, and then carefully swing the door open to the right as shown.

4.Remove the packing material from the imag- ing unit slot.

C4004U144AA

C4004U011AA

2.Pinch the release lever for the yellow imag- ing unit. (The colors of the imaging units are, from the left, yellow, magenta, cyan, and black.)

C4004U047AA

3. Swing the release lever toward you.

Protective tape

C4004U049AB

5.Remove the yellow imaging unit from its box and its protective plastic bag, and then place the imaging unit on a stable, level surface, such as a table.

NOTE

•The imaging unit can easily be damaged by light. Therefore, leave the imaging unit in its protective plastic bag until immedi- ately before it is to be installed.

•After removing the imaging unit from its protective plastic bag, make sure that it is not exposed to light, and immediately install it into the printer.

6.Hold the imaging unit in both hands, tilt it to the left, and then lightly shake it twice in the direction of the tilt. Next, hold the unit tilted to the right, and then lightly shake it twice in the direction of the tilt.

C4660U001AB

C4004U048AA

4004-7715-01	– 4 –

Image 5

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsPacking material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unitBe sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return