Cisco Systems CF2001P user manual To set the Sleep Mode parameter

Page 27

CF2001P

NEXT

■To set the “Sleep Mode” parameter

NOTE

When making settings according to the customer’s requests, refer to the procedure described below.

1.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

2.Click [Utility].

4. Click [Sleep Mode.]

C4004P600CA

5.Using the keypad in the External Panel Con- troller, enter the desired number of minutes, and then click [Enter].

NOTE

Select the [C] (Clear) key to erase the entered number.

C4004P059CA

6. Click [Exit].

C4004P565CA

3. Click [User’s Choice].

C4004P599CA

7.Click [Exit].

8.Check that the message displayed in the control panel changes from “Alert Printing suspended” to “Info”.

9.Exit the External Panel Controller.

NOTE

Before connecting or disconnecting the har- nesses of the IR port cable, be sure to turn off the printer and the converter.

4004-7715-01	– 26 –

Image 27

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsBlack imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached toWhile carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side doorRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return