Cisco Systems CF2001P Adjusting the Options, Checking the Paper Reference Position for PF-118

Page 30

CF2001P

NEXT

8.Affix the enclosed paper size label to Tray 2 as shown.

9.Affix the enclosed drawer number label as shown.

Paper size label

Drawer number label

C4004U141AA

10.Adjusting the Options

NOTE

•With the CF2001P, the adjustments of each option are performed with the servicing equipment. Therefore, start up the External Panel Controller, and make the adjustments with the appropriate setting.

•After adjusting the options, restart the printer.

■Checking the Paper Reference Position for PF-118

NOTE

•For details on the installing PF-118, refer to its Setup Instructions.

•To adjust PF-118, follow the instructions below.

•To exit the External Panel Controller, refer to step 14 on page 24.

1.Load A4-size (or Letter-size) paper into the paper drawer of the optional paper feed unit.

2.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

C4004P565CA

3. Click [Machine Adjust].

C4004P597CA

4004-7715-01	– 29 –

Image 30

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging UnitsShaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unitBe sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper Setting Up the Servicing Equipment CF2001PSetting Up the Converter Setting Up the Selector Connecting the Equipment Cables TorRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Making System Setting Checking the Date SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered numberTo set the Sleep Mode parameter Loading Paper TraySlide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test PatternChecking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone CablesPrecautions for Connecting a Telephone to the Data Terminal Transmission SettingsDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginningSetting the Telephone Number Return Initial Transmission