Cisco Systems CF2001P user manual Filling the Toner

Page 9

CF2001P

NEXT

Filling the Toner

NOTE

The toner bottles are not included. A bottle of toner is needed for each color (four in total) and should be purchased separately.

Be careful not to spill toner inside the printer or get toner on your clothes and hands. If toner gets on your hands, wash them using water and a neutral soap. If toner gets in your eyes, immediately rinse them, and then consult a medical pro- fessional.

1. Grasp the toner hopper door as shown, and then carefully swing the door up to open it.

3.Remove the yellow toner bottle from its packaging. Hit the bottom of the bottle against a strong surface, such as a desk or table, four or five times from a height of about 10 cm (4 in.). (Since the toner within the bottle may have become compacted, be sure to break it up by performing this step.)

NOTE

Be sure to hit the bottom of the toner bottle against the strong surface (the opening of the bottle should be pointing up).

C4004U058AA

C4004U010AA

 

2.Open the yellow toner hopper lid (leftmost) by swinging it toward you. (The toner hopper

lids are, from the left, yellow, magenta, cyan, and black.)

C4004U059AA

4.While holding the bottle securely, shake it well in all directions to mix up the toner.

C4004U060AA

5. With the rounded side (marked with “”) of the bottle mouth facing towards you, place the toner bottle on top of the hopper, and then press down on the bottle until it snaps into place.

C4004U061AA

4004-7715-01

– 8 –

 

Image 9
Contents CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsPacking material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unitBe sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it mayRemove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return