Cisco Systems CF2001P user manual Turn the cyan test pattern to its original ori

Page 19

CF2001P

NEXT

31

15.Feed the test pattern in direction “2” to read the row represented by “B”.

When feeding the test pattern to read the row represented by “B”, turn the paper to feed it in the correct direction without adjust- ing the X-Rite guide.

NOTE

18.Check that the area indicated in the dialog box appears in [OK].

NOTE

The area indicated appears in [OK] if the pattern was read correctly.

C4004P580CA

B D

C A

24

C4004U576AA

C4004P579CA

When reading the row in the test pattern represented by “B”, do not change the set- ting of the X-Rite guide.

16.Check that the area indicated in the dialog box appears in [OK].

NOTE

The area indicated appears in [OK] if the pattern was read correctly.

31

B D

C A

24

C4004U576AA

19.Feed the test pattern in direction “4” to read the row represented by “D”.

When feeding the test pattern to read the row represented by squares, turn the paper to feed it in the correct direction without adjusting the X-Rite guide.

NOTE

When reading the row in the test pattern represented by “D”, do not change the set- ting of the X-Rite guide.

		17. Turn the cyan test pattern to its original ori-
		17. Turn the cyan test pattern to its original ori-
3	1	entation, set the X-Rite guide to “30”, and
		then feed the pattern in direction “3” to read
		the row represented by “C”.

B D

C A

24

C4004U576AA

20.Check that the area indicated in the dialog box appears in [OK].

NOTE

The area indicated appears in [OK] if the pattern was read correctly.

4004-7715-01	– 18 –

Image 19

Contents CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsBlack imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached toWhile carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side doorRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return