Cisco Systems CF2001P user manual Connecting the Cables, Affixing the Support Label

Page 11

CF2001P

NEXT

4. Connecting the Cables

1. Make sure that the printer power cord is not plugged into the electrical outlet, and then insert the plug on the end of the power cord into the power cord connector on the printer.

5. Affixing the Support Label

Support label

Affix the support label on the right side of the top of the toner supply door.

NOTE

Affix the label that corresponds with the installed options.

C4005U552AA

C4004U589AA

2.Insert the plug on the other end of the power cord into an electrical outlet.

C4004U139CA

4004-7715-01	– 10 –

Image 11

Contents CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the UnitsBlack imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached toWhile carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side doorRemove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing EquipmentSetting Up the Converter Setting Up the Selector Tor Connecting the Equipment CablesRite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System SettingSpecifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameterTo set the Sleep Mode parameter Tray Loading PaperSlide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the OptionsClick PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the testChecking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada onlyTransmission Settings Precautions for Connecting a Telephone to the Data TerminalDate/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT SettingsSetting the Telephone Number Initial Transmission Return