Tripp Lite Single-Phase 7.5kVA, Single-Phase 10kVA Operation, Startup Self-Test, Failed Self-Test

Operation

Startup Self-Test

When you turn the UPS ON, it will enter Diagnostic Mode and perform a brief self-test lasting about 15 seconds. The results of the self-test are shown on the LCD screen in the sequence below.

STARTED WITH

AC INPUT

DIAGNOSTIC MODE FREQ OUT = XXHz

▼

DIAGNOSTIC MODE

INPUT AC OK

▼

DIAGNOSTIC MODE

INPUT AC OK

▼

DIAGNOSTIC MODE

BATTERY OK

▼

DIAGNOSTIC MODE

CHARGER OK

▼

DIAGNOSTIC MODE

AC/DC OK

▼

DIAGNOSTIC MODE TESTING INVERTER

▼

ONLINE MODE

LOAD = XXX% X.XXKW

COLD

START*

DIAGNOSTIC MODE FREQ OUT = XXHz

▼

DIAGNOSTIC MODE

INPUT AC BAD

▼

DIAGNOSTIC MODE

INPUT AC BAD

▼

DIAGNOSTIC MODE

BATTERY OK

▼

DIAGNOSTIC MODE

AC/DC OK

▼

DIAGNOSTIC MODE TESTING INVERTER

▼

ON BATTERY MODE

LOAD = XXX% X.XXKW

*Note: If the UPS is cold started, its BATTERY LED will be lit.

Failed Self-Test

If a problem is detected during the self-test, the LCD will display a error message. If your UPS displays any of the following messages in its LCD, call Tripp Lite Technical Support at (773) 869-1234 for service.

BAD BATTERY!

CALL FOR SERVICE

CHARGER FAILURE!

CALL FOR SERVICE

AC/DC FAILURE!

CALL FOR SERVICE

INVERTER FAILURE!

CALL FOR SERVICE

OUTPUT FAILURE!

CALL FOR SERVICE

FAN FAILURE!

CALL FOR SERVICE

12