Teac W-860R Parallel Recording, Continuous Recording Tape I to Tape Il, MIC/LINE Mixing Recording

Page 11

Parallel Recording

A single program source can be recorded onto the two cassette tapes simultaneously.

1.Follow the steps 1 to 6 described in "Recording with TAPE I and TAPE Il" except that in step 3, load cassette tapes into both TAPE I and TAPE Il. (See page 10)

2. Press the PARALLEL REC button.

Notes:

…Recording will start in the direction indicated by the direction indicator; therefore, set the direction beforehand.

…During recording, only following buttons are operational:

TAPE I : STOP button

TAPE Il : STOP, REC MUTE and PAUSE buttons

…To stop recording, press the STOP button. Both TAPE I and TAPE Il will stop.

Continuous Recording (TAPE I to TAPE Il)

1.Load two recordable cassette tapes into TAPE I and ll.

2.Set the NR SYSTEM and REC LEVEL as required.

3.Set the REV MODE switch to the ä

position.

 

 

4. Press the RECORD button, then

ï

PAUSE (or play) button of TAPE I to

Ë

start recording.

 

 

ä

After recording with

TAPE I is

 

completed, TAPE ll starts recording automatically in the forward direction.

5.To clear the continuous recording mode, press the STOP button.

Notes:

…In continuous recording, since recording with TAPE II always begins in the forward direction, make sure the cassette tape loaded in TAPE Il can be recorded on both sides.

…If the tape running direction is set to reverse side of TAPE l, recording will be done on only the reverse side of the tape loaded in TAPE l.

…Continuous recording from TAPE II to TAPE I is impossible.

MIC/LINE Mixing Recording (TAPE I and TAPE Il)

Using this unit, you can mix and record the MIC inputs and LINE IN inputs.

1.Plug microphones equipped with a standard phone plug into the MIC jack on the front panel of this unit.

2.Use headphones to monitor the inputs.

This prevents acoustic feedback, 'howling', that might occur if you listen to the sound from the speakers.

3.Press the RECORD button.

The deck enters the record-pause mode.

4.Balance the relative levels of MIC inputs and LINE IN inputs with MIC LEVEL and REC LEVEL knobs.

Be sure to keep the total input level within the limitations indicated by the peak level meters.

5.Press the PAUSE button to start recording.

ENGLISH

MIC/LINE Mixing Recording

LINE

W-860R

MIC

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 860R Important Safety Instructions Voltage Conversion General export models only PrecautionsTape Handling Before UseConnection Read This Before OperatingCleaning Tape Path Remote Control OperationMaintenance Battery InstallationFast Forward/CPS Button Name of Each ControlPitch Control Tape I only PlaybackPlayback with Tape I or Tape Il Continuous PlaybackBlank Scan Tape Counter ModeIntro Check Multi-CounterMulti-Counter Example How to Select any Required Tune Using CPSCPS Computomatic Program Search Record Muting Operation Tape I and Tape Il RecordingRecording with Tape I and Tape ll ErasingMIC/LINE Mixing Recording Parallel RecordingContinuous Recording Tape I to Tape Il Manual Editing with Pause Tape Il only Set the REV Mode switch to the desired positionDubbing Dubbing Copying from Tape I to Tape llTape I longer than Tape Synchro Reverse DubbingTape Tape I shorter than TapeConnection Timer Controlled OperationTimer Recording Specifications TroubleshootingManipulation des cassettes Avant utilisationRaccordements Lire ceci avant de faire fonctionner lappareilNettoyage du chemin de bande Boîtier de télécommandeEntretien Mise en place des pilesTouche de lecture avant Nom de chaque commandeLecture continue LectureLecture avec la Platine I ou la Platine Il Réglage de lacuité du son Platine I seulementPresser la touche Intro Check Compteur de bandeFonction de balayage des blancs Affichage du compteur Exemple CPS recherche informatisée de programmeRemarques sur la CPS RemarqueEffacement EnregistrementEnregistrement avec la Platine I et Platine Enregistrement mixage MIC/LINE Enregistrement parallèleEnregistrement continu Platine I vers Platine Il Enregistrement mixage MIC/LINECopie copie de la Platine I à la Platine Il CopieAppuyer sur une touche DUB Start High ou Normal Remarque Copie avec inversion synchroniséeRaccordements Utilisation dune minuterieEnregistrement par minuterie Lecture par minuterieSpécifications En cas de difficultéKassettenHandhabung Vor InbetriebnahmeAnschlüsse Bitte vor Inbetriebnahme lesenPflege und Wartung FernbedienungFunktionstasten Bezeichnungen der BedienungselementeFolgewiedergabe WiedergabeWiedergabe mit Deck I order Verwendung des Pitch Control Reglers Nur DeckDie Intro CHECK-Taste betätigen Anspielfunktion Intro CheckBandzähler LeerstellensprungZählwerkanzeige Wahl eines Titels mit der CPS-FunktionHinweise zur CPS-Funktion Stummaufnahme Deck I/Deck AufnahmeAufnahme mit Deck I und Deck LöschenZum auslösen der Aufnahme die PAUSE-Taste erneut drücken ParallslaufnahmeKontinuierliche Aufnahme Deck I zu Deck MIC/LINE-MischaufnahmeVorscht ÜberspielbetriebÜberspielbetrieb von Deck I auf Deck Manuelle Editierfunktion mit Pause nur DeckBand in Deck I länger als in Deck Überspielbetrieb mit Synchron BandumkehrBand in Deck I kürzer als in Deck Anschlüsse Timergesteueurter BetriebTimergesteuerte Aufnahme Timergesteuerte WiedergabeTechnische Daten StörungssucheCaricamento di una cassetta Prima dellusoCollegamenti Uso delle audiocassettePulizia del percorso del nastro Installazione batterieUso del telecomando ManutenzioneTasto di avanzamento rapido Nome dei comandiRiproduzione continua RiproduzioneRiproduzione per mezzo del deck I o del deck Il Comando Pitch Control solo DeckPremere il tasto Intro Check Funzione di ricerca degli inizi Intro CheckContanastro Contanastro Esempio CPS ricerca computerizzata di braniScelta di un particolare brano con la funzione CPS NotaPause CancellazioneRegistrazione Registrazione con deck I e deckRegistrazione con missaggio MIC/LINE Registrazione parallelaRegistrazione continuata Registrazione con missaggio MIC/LINEAvvertenza DuplicazioneDuplicazione copia dal deck I al deck Montaggio manuale con Pause solo deck IlDeck I più lungo del Deck Duplicazione ad inversione sincronizzataDeck I più corto del Deck Collegamenti Uso del timerRegistrazione via timer Riproduzione via timerDati tecnici DiagnosticaPower Carga de un cassette Previo al empleoConexiones Manipulación de cintasLimpieza de la trayectoria de la cinta Operación de control remotoMantenimiento Instalación de las pilasNombre de controles Dolby TimerReproducción continua ReproducciónReproducción con Tape I o Tape Uso de Pitch Control Tape I solamentePresione el botón Intro Check Contador de cintaFunción de búsqueda de secciones sin grabar Contador ComputadoraCómo seleccionar la canción deseada utilizando CPS Natas sobre CPSSilenciamiento de grabación GrabaciónGrabación con Tape I y Tape BorradoGrabación de mezcla MIC/LINE Grabación paralelaGrabación continua Tape I a Tape Atencion Copia de cintasCopia de cintas de Tape I a Tape Edición manual con Pause Unicamente TapeLa cinta de Tape I es de mayor duración que la de Tape Copia con inversión sincronizadaPresione uno de los botones DUB Start High o Normal Nota La cinta de Tape I es de menor duración que la de TapeConexiones Grabación y reproducción programadasGrabación programada Reproducción programadaEspecificaciones Detección de problemasBehandelen van cassettes Alvorens in gebruik te nemenAansluitingen Lees dit alvorens het toestel in gebruik te nemenInleggen van de batterijen Bediening op afstandOnderhoud Reinigen van de onderdelen waarlangs de band LooptGesynchroniseerde Toets Bedienigstoetsen Benaming van de bedieningsorganenDoorlopende weergave WeergaveWeergave met Tape I of Tape Bandsnelheid Alleen TapeDruk op de Intro Check toets BandtellerBIanko-aftastfunktie Bandteller Voorbeeld CPS fragmentzoeksysteem Computomatic Program SearchOpmerkingen aangaande het CPS fragmentzoeksysteem OpmerkingOpnamedemping Tape I/TAPE OpnameOpname met Tape I en Tape UitwissenLevel Gemengd opnemen van mikrofoon- en IijnsignalenParallelopname gelijktijdige opname op beide cassettes Doorlopende opname Tape I naar TapeLET OP DubbenDubben Kopiëren van Tape I of Tape Handbediend monteren met de Pause toets Alleen TapeTape I langer dan Tape Tape I korter dan TapeAansluitingen Timer-geregelde funktiesTimer-geregeld opnemen Timer-geregeld weergevenTechnische gegevens Oplossen van moeilijlkhedenOsservazioni riguardanti la registrazione con luso del timer Anmerkungen zur Timer-gesteuerten Aufnahme
Top Page Image Contents