Powerware FE/QFE UPS manual Where is the Battery Ah value from Table, Dwh

The date is parameter 10. To display the date, follow these steps:

Press this key:	Display shows:
[DISPLAY]	'LVSOD\￿
[1][0]	'LVSOD\￿	￿￿
[ENTER]	￿￿ 'DWH￿ ￿￿￿￿￿￿￿￿
[PROGRAM]	￿￿ 3JP￿

sd If your FERRUPS UPS is configured to use an external battery cabinet, you must program the battery capacity in ampere-hour (Ah) for the total number of battery packs used in the UPS. If you purchased one of the FERRUPS battery pack options available from Powerware, select the Ah value from Table 1.

Before programming the battery Ah, enter the user password following the instructions in “Entering Passwords” on page 28. To change the battery Ah, parameter 69 (Batt Ah), follow these steps:

Press this key:	Display shows:
[DISPLAY] [6] [9] [ENTER]	￿￿ %DWW $+ >'HIDXOW@
[PROGRAM]	￿￿ 3JP￿
[Ah Value from Table 1]	￿￿ 3JP￿	>[[[@
[ENTER]	￿￿ 3JP￿	>QHZ YDOXH@

where [[[ is the Battery Ah value from Table 1.

Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com 21