Powerware FE/QFE UPS manual Indicator Status

Table 2. Indicator Status

h	r	d
AC LINE	On	TheNOTEUPS is getting power from the AC input power source.
		The AC LINE indicator does not illuminate for FE models with serial numbers
		25000 and greater until the UPS ON/OFF switch is turned to the ON position.
	Off	: The UPS is not getting input power.
		: There is a power outage.
		: The AC input breaker is tripped.
		: The UPS is unplugged.
		: For FE models with serial numbers 25000 and greater, the ON/OFF switch is not in
		the ON position.
	Flashing	Not applicable.
READY	On	The UPS is ready to provide battery backup power when needed.
	Off	The UPS cannot provide battery backup power because:
		: It is in the Line Condition mode or the Off mode (see “Using the Control Panel” on
		page 27).
		: The batteries may be discharged.
		: It may be running on battery power.
	Flashing	The UPS is testing the batteries as part of the automatic system test (see “Automatic
		System Test” on page 31); or, you have started a timed shutdown (see Table 8 on
		page 44).
CHARGING	On	The UPS is charging its batteries.
	Off	The battery charger is off; batteries are at full charge.
	Flashing	Not applicable.
BATTERY POWER	On	The UPS is providing power from its batteries; it is in the Inverter On mode.
	Off	The UPS is providing conditioned power from the AC input power source, or the UPS is
		off.
	Flashing	The UPS is testing the inverter as part of the automatic system test (see “Automatic
		System Test” on page 31).
ALARM	On	The UPS is warning you that an alarm exists. If you have not silenced the alarm, the
		beep sequence identifies the problem (see “Alarms” on page 59.) If you have a control
		panel, an alarm message appears on its display.
	Off	No alarm exists.
	Flashing	Not applicable.

26 Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com