Powerware FE/QFE UPS manual DB-25 Port Settings, Keystroke Commands, Action Key Sequence

m

Table 6. DB-25 Port Settings

r	r r	W
Connector	25 pin D (female) wired as DCE.
Format	ASCII, 8 bits, 1 stop bit.	Standard setting or
	Most significant bit set to 0.	7/8 bits, 1/2 stop
Baud Rate	1200	50–38400
Parity	None	Odd, Even, or None
Duplex	Full	Full or Half

nd Turn your terminal on or run your terminal emulation software. Then press [ENTER] on your keyboard; a prompt appears on the screen. The prompt varies depending on your current password level:

=>	Normal prompt
User=>	User Password has been entered

od Press [ENTER] on your keyboard a few times to verify that the UPS responds.

rd To control or monitor the UPS, simply type the desired command and press [ENTER].

Table 7 shows what keystrokes to use as you type commands or view displays. See Table 8 for more information on UPS commands.

Table 7. Keystroke Commands

Action	Key Sequence
Delete last character typed.	[BACKSPACE] or [CTRL]-[H]
Delete line.	[CTRL]-[X]
Pause displays that take more than one screen.	[CTRL]-[S]
Resume scrolling. (Turn Pause off.)	[CTRL]-[Q]

Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com 43