Powerware FE/QFE UPS manual Paramkeywords, Numbers or names of the starting and ending par meters

m

Command	Short	Password	Example: password 377enters the User Password.
			Function
	Form
paramkeywords	pk	Depends	Displays all parameters and their keywords (the names you can use with
		on	commands). You can also display a range of parameters by entering the
		parameter	numbers or names of the starting and ending par meters.
		password
password	pw	None	Allows you to enter the User Password. Typing passwordalone clears
			the current	sword.

program	pr	Depends
		on
		parameter
		password

Lets you set the value of any parameter. You must enter the appropriate password before you reset the value. See the Password command above. Format: PR [parameter # or name] [newvalue]

Example: PR0815resets the time (parameter 0) to 8:15 a.m.

remote	rm	None	Configures the RS-232 port so the connected terminal works like a
			control panel.
systemmode _	sm	None*	Typing systemmode alone displ ys which system mode is now active.
shutdown	sd	None*	Shuts down the UPS output in 60 seconds (if you enter shutdown alone)
or			You can use systemmode with a, o, i, or lto enter one of the modes
			or the number of secon s you specify after the command. The READY
shutdown autostart	sd a		indicator flashes until the UPS shuts down. If you specify autostart, the
			UPS restar hortly after power returns.
shutdown cancel	sd c	None*	Cancels a shutdown started with the shutdown command.
shutup	sh	None	Turns off audible alarm.
status	s	None	Shows date, ti e,	status, present system mode, active alarms,
			and the value of various system parameters.
			below.
systemmode auto	sm a	None*	Enters the Auto mode. This is the normal FERRUPS UPS mode. In this
			mode, the UPS provides conditioned AC power to your equipment; if
			there is a power outage, the UPS is ready to switch to battery power.
systemmode off	sm f	None*	Enters the Off mode. In this mode, the UPS is not providing power to your
			equipment, but you can still use the UPS control panel.
systemmode inverter	sm I	None*	Enters the Inverter On mode. In this mode, the UPS is converting DC
			battery power to AC power for your equipment.
systemmode	sm l	None*	Enters the Line Condition mode. In this mode, the UPS provides
linecondition			conditioned AC power to your equipment, but it does not switch to
			battery power if there is a power outage. Instead, the UPS sounds a Low
			AC Out alarm.

*If you change parameter 39 to “Yes,” this command requires a User password.

46 Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com