3Installation
4Slide the cover over the stacked modules and secure with four of the 1/4.20x 1/2 screws provided. Tighten the screws until the cover's flanges are pulled flat against the caster base.
5Make sure the Bypass switch on the Bypass Module rear panel is in the NORMAL position (see Figure5 or Figure6).
427.7 mm
(16.84I)
251.6 mm
(.1I)
Power Input
Connector
Battery
Connector
Input Circuit
Protector
UPS Module
Circuit Breaker
Breaker Tie
Battery Module 
Y)Cord
Power Output
Receptacles
Utility Input
Connector
BDM (60 Hz) 
Figure 5. UPS with BDM Rear Panel
Serial Port
Tie Wrap
Mounts
Power Output
Receptacle
REPO
Receptacle
External
Battery
Connector
Battery Cord
Bypass Switch
Load Circuit
Protectors
Depth of Unit: 400.0 mm (15.75I)
26 | #" ! " ! # 6$5$ I!!# |