Lucent Technologies 3000 VA manual UPS with Bypass Module Rear Panel 6%Hz BDM Shown

Page 52

4UPS Operation

3Remove the cord connections to the back of the UPS.

The UPS enters Battery Mode for several seconds. The Indicator turns off and the UPS shuts down.

4Turn the circuit breaker on all battery cabinets to the OFF (O) position.

5Disconnect the battery connector located on the UPS rear panel.

6Remove the UPS.

Power Input

Connector

Battery

Connector

UPS Module

Battery

Circuit

Breaker

Battery

Module

Power Output Receptacle

	Bypass
Y$Cord	Switch

BDM (60 Hz)

Figure 8. UPS with Bypass Module Rear Panel (6%Hz BDM Shown)

4	#" ! " ! # 6$5$ I!!#

Image 52

Contents ##*&% % *& %+# +%* !%&# +*# &, -*$ Page Page Special Symbols UPS with BDM Installation UPSQuick Start UPS with BIM Installation Quick Start Able of Contents Troubleshooting Ntroduction Model 3000 UPSUPS Model and Battery Configurations Load RequirementsBattery Times for the UPS and BIM Battery Times for the UPS with BDMIntroduction This Manual Contains Important Safety Instructions Afety WarningsSikkerhedsanvisninger Belangrijke Veiligheidsinstructies Tärkeitä turvaohjeita Consignes de Sécurité Safety Warnings Wichtige Sicherheitsanweisungen Importanti istruzioni di sicurezza Safety Warnings Viktig Sikkerhetsinformasion Regulamentos de Segurança Requisitos de seguridad Afety WarningsAfet3 Warnings Viktig säkerhetsinformation Safety Warnings Safety Warnings UPS and Battery Module Storage Important Installation Notes Read Before Installing the UPSNstallation Unpacking and InspectionSystems That Require Contact Closure UPS with Bypass Module InstallationSystems That Require a Serial Interface UPS with Distribution Module Setup UPS with Isolation Module Setup For Stability Repo UPS with BIM Rear Panel Installation UPS with Hardwired Bypass Module Rear Panel Hz Hardwired BIM Terminal Block Repo Installation Mounting Holes Phase 200/208/220/230/240V UPS with Bypass Module StartupOutput Voltage Indicators Troubleshooting Tips Installation S!!! O!!P!!E!!R!!A!!T!!I!!O!!N UPS Front PanelNormal Mode Operating ModesBypass Mode Battery ModeBattery Test on Demand DiagnosticsBattery Start Using the Bypass Module Using Maintenance BypassUPS Shutdown Changing the Output VoltageUPS with Bypass Module Rear Panel 6%Hz BDM Shown 604Hz BDM 240 Output Voltage Indicators Initial Communications Settings OmmunicationFront Panel ommuncatons Access OptionsUPS Serial Communications Menu Ascii Select LAN Configuration Select Baud Rate UPS Communications Interface Port Serial Port LocationCommunications Mode Reference Chart PWR.FAILUPS Physical Specifications UPS Model 3000 SpecificationsPecifications Model 3000 Specifications with the 60Hz BDM Model 3000 Specifications with the 50Hz BIMUPS Technical Specifications EMC# ! ! # 6$5$ I!!# Roubleshooting Troubleshooting Silencing the Alarm Resetting the UPSService and Support Parts List PDM06Ndex Numeric LOWBATT,49 Over temperature,alarm,58 UTILFAIL,49 FCC Statement Class aEuropean EMC Statement EC Declaration of Conformity