Installation 3
19Refer to your national and local electrical codes for acceptable external wiring practices.
WARNING Only qualified service personnel such as a licensed electrician should perform the hardwired installation
20Remove the three screws on the terminal block access cover with a Phillips screwdriver and remove the cover (see Figure7).
Access Cover | Access Cover Screw |
Screw |
|
| Bypass Switch |
Input Breaker | Terminal Block |
| |
1/2I Input | Access Cover |
Conduit Access |
|
Access Cover | 1/2I Output |
Screw | Conduit Access |
Figure 7. UPS with Hardwired Bypass Module Rear Panel
CAUTION For Bypass systems with hardwired outputs overcurrent protection and suitably rated disconnect switches for the output AC circuits are to be provided by either the protected equipment or the customer's distribution panel
#" ! " ! # 6$5$ I!!# | 29 |