5Communication
Front Panel ommun"cat"ons Access
Before you access the front panel, review the following configurations and note the indicator that corresponds with the communication mode.
iNOTE Only the Printer Mode front panel options change the baud rate. Use the UPS Serial Communications Menu to select other baud rates (see page 47).
OPTIONS
Pr"nter Mode, 2400 Baud, Novell ontacts Select this mode for the power management software.
OVERLOAD
1 2 3
OUTPUT ON
Ind"cator Legend
Unlit
Amber
Green
Flashing
PANEL OMMUNIATION
Novell0Style LAN ontacts (Default) Any baud rate other than 2400 or 19200 with Printer Mode, or not Printer Mode.
OVERLOAD
1 2 3
OUTPUT ON
3om LAN Manager
Any communication mode and baud rate option.
OVERLOAD
1 2 3
OUTPUT ON
FRONT
AS/4000Style LAN ontacts, No Ser"al | Pr"nter Mode, 19200 Baud (network |
Select this mode for the monitoring software. | dev"ces), Novell ontacts |
OVERLOAD | OVERLOAD |
1 | 1 |
2 | 2 |
3 | 3 |
OUTPUT ON | OUTPUT ON |
F"gure 20. Front Panel ommun"cat"on Opt"ons
To access the front panel communication options, perform the following steps:
If the UPS is powered on, prepare your equipment for shutdown.
Press and hold the Output 
Off button until the long beep ceases (approximately three seconds).
Unplug the UPS. Wait until all indicators turn off and then continue to the next step.
Plug in the UPS while pressing the Output 
Off button until the alarm beeps. All indicators begin flashing.
46 | #" ! " ! # 6$5$ I!!# |