Briggs & Stratton 202826GS Equipment Description, Customer Responsibilities, Delivery Inspection

Page 7

Equipment Description

This product is intended for use as an optional home generator system which provides an alternate source of electric power and to serve loads such as heating, refrigeration systems, and communication systems that, when stopped during any power outage, could cause discomfort or inconvenience. This product does not qualify for emergency standby as defined by NFPA 70 (NEC).

Customer Responsibilities

Read and follow the instructions given in the Operator’s Manual, especially the section regarding selecting essential circuits.

Follow a regular schedule in maintaining, caring for and using your home generator, as specified in the Operator’s Manual.

Installer Responsibilities

Read and observe the safety rules.

Install only an UL approved transfer switches that is compatible with the home generator.

Read and follow the instructions given in this Installation and Start-up Manual.

IMPORTANT: If operating the generator below 40°F, it is recommended that a battery and oil warmer be installed. If operating the generator below 32°F, a battery and oil warmer must be installed. Both items are available at your local servicing dealer.

Unpacking Precautions

The unit is shipped bolted to its mounting pad, ready for installation. Avoid damage from dropping, bumping, collision, etc. Store and unpack carton with the proper side up, as noted on the shipping carton.

caution

Installing the 15A fuse could cause the engine to start.

Observe that the 15 Amp fuse has been removed from the control panel for shipping.

DO NOT install this fuse until all plumbing and wiring has been completed and inspected.

Delivery Inspection

After removing the carton, carefully inspect the home generator for any damage that may have occurred during shipment.

IMPORTANT: If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor’s memo of loss or damage. If loss or damage is noted after delivery, separate the damaged materials and contact the carrier for claim procedures. Missing or damaged parts are not warranted.

Shipment Contents

The home generator is supplied with:

Home generator

Pre-attached mounting pad

UL569/CSA8.3-listed flexible fuel hook-up

This installation and start-up manual

Operator’s manual

Illustrated parts list manual

Installation checklist

Two access door keys

Four lifting hole plugs

Oil fill spout

One spare 15A fuse

2 Pole connector - 240V from house

10 Pole connector - Sensing and control wires

Air intake engine cover

Alternator cover

Remote LED indicator kit (red LED/plate/screws)

Required Specialty Tools/Equipment

Two 48” lengths of 1” pipe (NOT conduit)

Hole punches for 16ga steel

Torque screwdriver, 5 to 50 inch-pound range

Image 7
Contents Home Generator System Model Number Model Revision Serial Number Where to Find UsDate of Purchase Generator EngineTable of Contents Hazard Symbols and Meanings Safety RulesPage Never operate generator without protective housing or covers InstallationEquipment Description Installer ResponsibilitiesUnpacking Precautions Shipment ContentsGenerator Location Home Generator LocationGeneral Location Guidelines Lifting the Generator Fuel and Electrical Inlet LocationsGaseous Fuel System Access DoorsTo Open an Access Door To Close an Access DoorNo leakage is permitted LP Vapor Natural Fuel ConsumptionNatural Gas LP Vapor Fuel Pipe SizingPole Connector Plug System Connectors+12 Volt DC, .5 Amp Output Internal power supply Grounding the Generator Transfer Switch CommunicationFault Detection System Generator AC Connection SystemSystem Control Panel Final Installation ConsiderationsFuel Supply System Initial Start-up No Load Engine AdjustmentPage Schematic Wiring Diagram Operation Setting Exercise TimerInstallation Inspection ControlsGenerador doméstico Número de Modelo Revisión Número de Serie Dónde encontrarnosFecha de compra Generador MotorMandos Utilización Instrucciones importantes de seguridad InstalaciónBRIGGSandSTRATTON.COM Símbolos de Peligro y SignificadosAte para arriba el pelo largo y quite la joyería Tensión peligrosaNo modifique al generador en ninguna forma Instala el fusible se puede producir el arranque del motorInstalación Ubicación del Generador Ubicación del Sistema de Generador de DomésticoPautas Generales para la Ubicación del Generador Elevación del Generador Dimensiones de la Entrada para Electricidad y CombustiblePara cerrar una puerta de acceso Puertas de AccesoSistema de combustible gaseoso Para abrir una puerta de accesoSe debe contar también con una abertura para manómetro Vapor de Gas Dimensiones de la Cañería de CombustibleConsumo de Combustible Gas Natural Vapor de PLCableado para toma bipolar Conexiones de SistemaCableado para toma de 10 polos Salida de +12 V CC y 0,5 a Fuente de alimentación internaConexión a Tierra del Generador Sistema de Conexión de c.a. del GeneradorInterconexiones del Circuito de Control Comunicación del conectadorSistema de Suministro de Combustible Panel de Control del SistemaAjuste del Motor Arranque inicial sin cargaInstale el fusible de 15 Amperios en el panel de control Cargue el generador a plena carga MandosUtilización Secuencia de operación automáticaInspección posterior a la instalación Configuración del temporizador de prácticaTemporizador de enfriamiento del motor Manuel d’Installation et Démarrage Numéro de modèle Révision Numéro de série Où nous trouverDate d’achat Génératrice MoteurCommandes Fonctionnement Directives de sécurité importantes InstallationCertains composants de ce produit ainsi que les Symboles de Danger et MoyensDirectives de sécurité importantes SécuritéTension dangereuse Avis Précautions Lors du Déballage Responsabilités de l’InstallateurDescription de l’équipement Responsabilités de l’AcheteurInstallez l’unité à l’extérieur Seulement Emplacement du Génératrice d’état d’AttenteDégagement Autour de la Génératrice Soulèvement de la Génératrice Le système de combustible gazeux Portes d’AccèsCapacité Retrait des commandesLa sortie pour manomètre permet l’installation temporaire Aucune fuite ne peut être toléréeGrosseur du Tuyau de Combustible Dimension du Réservoir de Propane NécessaireConsommation de Combustible Gas Naturel Vapeur PLConnexions de système Système de Détection des Pannes Interconnexions du Circuit de CommandeMise à la Masse de la Génératrice Communication du commutateur de transfertConsidérations pour l’installation finale Tableau de Commande du SystèmeSystème d’Alimentation en Combustible Recommencez le processus jusqu’à ce que le moteur démarre Démarrage initial sans chargeRéglage du Moteur Réglez l’interrupteur de système de la génératrice sur AutoFrançais Séquence de fonctionnement automatique CommandesVérification installation Fonctionnement