Operators Manual
ALS 330/430
3.2.3Capacitive label sensor
For transparent labels the standard photo label sensor doesn’t work. In this case, use a mechanic or a capacitive label sensor.
Note: For correct automatic initialisation, the CONT parameter has to be set to a manual value, if you using not the standard photo sensor.
A mechanical sensor is limited in the speed. The bounce at the label edges produces wrong signals.
There is optional a capacitive label sensor available (Leuze GK14/24L).
Adjustment of the sensor is carried out as follows (Figure 5):
1.Set sensitivity to maximum by turning the Potentiometer clockwise. Then rotate ½ turn anticlockwise.
2.Remove label material out of sensor.
3.Perform base adjustment, that both LED “base adjustment” have the same brightness.
4.Put label with backing paper inside the sensor. Doing this, the LED “switch output” and the left LED “base adjustment” are switched off. With backing paper only in the sensor both LED are switched on. If the LED are lightning with label inside the sensor, increase sensitivity in ¼ turn steps by rotating the sensitivity clockwise.
5.Check the adjustment over the complete length of label.
Carry out the above adjustment after mounting, cleaning or increasing sensitivity.
Figure 5 Capacitive sensor
Release 4/06 | Page 20 | Preparing the machine |