Sharp UX-600M operation manual Optional Settings, Setting 8 Dial Mode

Chapter 9 Optional Settings

Setting 3: RECALL INTERVAL

This sets the amount of time your fax will wait between automatic redials when the line is busy. Enter "01" for 1 minute, "02" for 2 minutes, etc., up to a maximum of 15 minutes.

•Initial setting: "05"

Setting 4: RECALL TIMES

This sets the maximum number of times your fax will automatically redial if the line is busy. Enter any number from "00" to "15".

•Initial setting: "02"

Setting 5: TEL/FAX REMOTE NUMBER

This sets the 1-digit number for activating fax reception from an extension telephone. Enter any number from "0" to "9".

•Initial setting: "5"

Setting 6: REMOTE RECEPTION SELECT

This turns detection of the code for activating fax reception from an extension phone on or off. Press "1" to turn detection on, or "2" to turn detection off.

•Initial setting: "1"

Setting 7: TRANSACTION REPORT PRINT SELECT

This sets the condition for printing out a Transaction Report. Enter a number from "1" to "5" as follows:

"1" (ALWAYS PRINT): A report will be printed after each transmission, reception, or error.

"2" (ERR/TIMER/MEM): A report will be printed after an error, timer operation, or memory operation.

"3" (SEND ONLY):	A report will be printed only after a transmission.
"4" (NEVER PRINT):	A report will never be printed.
"5" (ERROR ONLY):	A report will be printed only after an error occurs.
• Initial setting: "5"

Setting 8: DIAL MODE

This sets the mode of dialing. Press "1" if you are on a touch-tone line, or "2" if you are on a pulse dial line. (If you don’t know which type of line you have, try making phone calls with both settings and see which one works.)

•Initial setting: "1"

75