Muratec M860, M840, M880 manual Adjusting Monitor and Ringer Volume, To setting monitor volume

Getting Started

Adjusting Monitor and Ringer Volume

For your convenience, your fax machine allows you to set the volume of the monitor speaker and of the ringer.

To setting monitor volume

1.Press monitor/call. You should hear a dial tone. If not, go back and re-check your connections so far.

2.Adjust the volume with the monitor speaker dial on the back of your fax.

3. Press monitor/call once more to turn off the monitor.

To setting ringer volume

You may set the ringer volume to one of three levels: high, medium, or low.

To do so, use the ringer volume switch, also at the left side of your fax machine.

Attaching A Second Telephone or Answering Machine

Note: If you have an M880, do not connect the answering machine into your fax

machine. Because your M880 already has a high-quality answering machine built in (see “Section 4; Answering Machine” page 4.1), it is not designed to be used with another answering machine, connected or not. We strongly recommend that you use the fax machine as the only answering machine on its phone line.

To connect the other phone to your fax machine:

Plug the other phone’s telephone line cord into the EXT.TEL jack on the back of your fax machine.

Note: Do not plug your second phone into the wall jack. In order for your fax machine and your second phone to work together, the second phone must be connected to the fax machine’s EXT.TEL jack, as shown.

Note: For information on how to use either an answering machine or a connected second telephone with your fax machine, see “Receiving Faxes”, page beginning on page 1.18.

1.13