1. Introduction and Installation
1.6 Paper tray
Insert the paper tray (1) into the slot (2) on the back of the unit.
1
2
3
Note:
LDo not place the unit in an area where the paper tray may be obstructed (i.e., by a wall, etc.).
LKeep this surface (3) away from walls etc. more than 50 mm to let the unit cool down.
1.7 Paper stacker
Line up the slots (1) in the paper stacker with the pegs (2) on the bottom of the unit, then insert the two tabs of the paper stacker into the slots on the unit (3).
2
3
1
Note:
LDo not place the unit in an area where the paper
stacker may be easily bumped into.
LDocument and recording paper will be ejected from the front of the unit. Do not place anything in front of
the unit.
LThe paper stacker can hold up to approximately 30 sheets of printed paper. Remove the printed paper before the paper stacker becomes full.
12