Panasonic CY-TUN153U warranty Electrical Connections, Module CY-EM100U

Page 14

English

Electrical Connections

 

 

 

 

Wiring Diagram

 

25

 

 

Caution

This unit is designed for use in a car having a 12 V negative ground battery system.

To prevent damage to the unit, be sure to follow the connection diagram.

Do not insert the power connector into the unit until the wiring is completed.

Be sure to insulate any exposed wires to prevent short circuiting with the car chassis. Bundle all cables, and prevent cable terminals from touching any metal parts.

Note that if your car has a driving computer or a navigation computer, disconnecting the cable from the battery may clear the memory.

Run the cords avoiding the spots where the temperature can be extremely high.

Fit a vinyl cap over unused connection terminals, to prevent contact with metal parts etc.

English

This unit cannot be operated alone.

This unit is designed for users to connect one or more system devices to Panasonic car 26 audio/AV unit at the same time.

Connecting with Head Unit (CQ-VD7003U) and Expansion

Module (CY-EM100U)

Head Unit:

CQ-VD7003U

TV Tuner: CY-TUN153U

TV Antenna

RCA cord (option)

Power connector

Refer to page 24 for the TV antenna connection.

Not used.

Video (Yellow)

(Fuse 3 A)

Power Control Lead (Blue/white stripe)

To the external amplifier control power lead of the Head Unit.

To ACC power, 12 V DC, if the Head Unit has no external amplifier control power lead.

Ground Lead (Black)

To a clean, bare metallic part of the car chassis.

Battery Lead (Yellow)

To the car battery, continuous 12 V DC.

Head Unit/Expansion Module Connecting Cable To one of the system-up connectors (input)

TV Tuner:

CY-TUN153U

Head Unit/Expansion Module Connecting

Cable (supplied with CY-EM100U)

Video (Yellow)

 RCA cord

Video input

Port 1 IN to 4 IN System-up connectors (input)

Video input

Parking Brake (Side Brake) Connection Lead (Bright green)

TO EXPANSION MODULE

Expansion Module:

CY-EM100U

VIDEO

REMOTE IN

(Yellow)

Not used.

Note:

Strip about 5 mm of the lead ends for connection.

Be sure to fully plug in the connectors. Secure them with clamps and tapes.

All other installation methods require the use of dedicated metal fittings. Consult with a qualified servicing engineer or your dealer if other methods are required.

Be sure to wire the parking brake (side brake) for safety and preventing accidents.

If the Expansion Module (CY-EM100U, option) is not connected and the ACC is not mounted on the vehicle:

Connect the power control lead of this unit to the external amplifier control power lead of the Head Unit. If this connection is not made, the battery will run down.

Note:

Refer to individual instruction and installation manuals for each device for detailed installation and wiring.

Connect this unit to the Expansion Module (CY- EM100U, option) with the Head Unit/Expansion Module Connecting Cable and RCA cord (video) (supplied).

When the device that provides video output is connected to the System-up Connector, connect the video cable to input connector below the port to which the System-up Connector is connected.

Note for the Head Unit remote control unit (page 13):

With some Head Units, the Head Unit remote control unit may not have buttons intended specifically for TV operation, so some operations cannot be used for TV operation. But that does not mean that the tuner or the Head Unit are malfunctioning.

26

 

CY-TUN153U

CY-TUN153U

 

27

 

 

 

 

 

 

Image 14
Contents CY-TUN153U Safety Information Case of battery leakage  Take care not to damage the leadsFeatures Contents Vancouver Customer Services Directory Limited WarrantyToronto Preparation Components SettingsRemote Control Unit Diver Diversity Antenna Setting To use the two TV antennae ProvidedSystem Connection Example TunerTV Tuner Unit Names of Controls and Terminals Diver SettingRemote Control Unit Channel Preset Preset Channel CallingInstallation Hardware For Installation InstallationInstallation Precautions Installation Hardware For WiringMount the unit on the car carpet By using Velcro tape  Mounting the Tuner UnitMounting the TV Antenna Electrical Connections Module CY-EM100UConnecting with Head Unit CQ-VD6503U Yellow Not used Video YellowConnecting with Rear Monitor CY-VHD9401U When Connecting the Rear Monitor CY-V7001U, option Check the wiring TroubleshootingProblem Possible cause  Possible solution CommonSpecifications Tuner for Analog TV onlyInformations concernant la sécurité Mise en gardeInformations concernant la sécurité suite Caractéristiques Raccordement du fil de Connexion du frein à mainLimitations ET Exclusions Répertoire des services à la clientèle Garantie limitéeRéparation Sous Garantie Préparatifs Pièces TélécommandeRemplacement de la pile RéglagesPour utiliser les deux antennes Fournies Antenne de télévision diversitéRéglage d’antenne Diver Diversité VD6503U, module d’extension CY-EM100U et syntonisateur téléCet appareil ne peut pas fonctionner de manière autonome Exemple de raccordement à la chaîneVD6503U et syntonisateur télé Syntoniseur télé CY-TUN153USyntoniseur télé TélécommandeRéglages de Diver Commandes de base du téléviseur Présyntonisation de canal Rappel de canal PrésyntoniséInstallation PréparatifsMontage du syntonisateur Installation suiteRecommandé La vis autotaraudeuseMontage de l’antenne de télévision Syntoniseur télé Raccordements électriquesModule d’extension CY-EM100U CQ-VD7003U Raccordements électriques suiteUnité d’opération UnitéTV OUT Raccordement à l’unité d’opération CQ-VD7001UCQ-VD7001U TV-CONTProblèmes communs suite DépannageSi vous soupçonnez une anomalie Dépannage suite Fiche techniqueRespete las siguientes advertencias durante la instalación Información de seguridadAdvertencia Incluso LA MuerteRespete las siguientes precauciones durante la instalación Información de seguridad continuaciónPrecaución Contenido CaracterísticasUnidad de mando a distancia Preparativos ComponentesAjustes Para utilizar las dos antenas de Televisión suministradas Antena de televisión de diversidadAjuste de antena Diver Diversidad Para usar las dos antenas OpcionalesEsta unidad no funciona por sí sola Ejemplo de conexión del sistemaExpansión CY-EM100U y sintonizador de televisión Dispositivos conectadosUnidad de mando a distancia Power SupplyNombre de controles y terminales Ajustes Diver BandSelección de los canales Presintonizados Precauciones sobre la instalación InstalaciónPreparativos Hardware para la instalación Para la instalaciónEstacionamiento freno de mano Montaje de la unidad del sintonizadorConexión del cable de conexión del freno de Freno de manoPara mejorar la fijación, tenga en cuenta lo siguiente Inserte la placa de conexión a tierraPreparativos Del cuerpo de la antena y péguelo. aMódulo de expansión CY-EM100U Conexiones eléctricasConexión de la unidad principal CQ-VD7003U y el Sintonizador de TVUnidad principal CQ-VD6503U Conexiones eléctricas continuaciónUnidad principal AV2-IN To Head Unit Video RemoteAl conectar el monitor trasero CY-V7001U, opción Conexión a la unidad principal CQ-VD7001UConexión al monitor posterior CY-VHD9401U Monitor traseroComún Solución de problemasSi sospecha que algo no funciona Solución de problemas continuación Especificaciones Panasonic Canada Inc