English
Names of Controls and Terminals
DIVER Setting
English
15
TV Tuner Unit
TV ANT IN
Terminal for connecting TV antennas (supplied)
TV OUT
Terminal for connecting a Rear Monitor
L (White)
REMOTE IN (Black) Terminal for connecting a Head Unit’s remote output terminal.
R(Red)
Refer to page 12 about the DIVER (Diversity) Antenna setting.
Read the explanation on this page as required.
[PWR] (Power) | [ENT] (ENTER) |
| [MENU] |
DIVER (Diversity) Antenna Setting
Diversity TV Antenna:
Of the two antennae connected to the system, the one with the best reception is automatically selected for TV reception. Turning DIVER (Diversity) setting to “ON” reduces noise.
Confirm “ON” to receive a good reception.
Default: ON
Setting: ON/OFF
Press [PWR] (Power). Press [MENU].
16
TO HEAD UNIT/EXPANSION MODULE (System-up Connector)
Terminal for connecting a Head Unit
POWER SUPPLY
Terminal for connecting to the power connector
Remote Control Unit
[PWR] (Power)
Switches on/off the power. (page 18)
[BAND]
Selects TV band. (page 18)
Searches for channels and memorizes them automatically. (page 19)
[] (CH DOWN) [] (CH UP)
Selects an operation or item. (page 17)
Selects or searches the channel. (page 18)
VIDEO (Yellow)
Connect RCA cord to the video input terminal of the Head Unit when connecting Head Unit/Expansion Module Connecting Cable to the Head Unit.
Note:
Point the emitter of the remote controller at the Head Unit or the monitor.
[ENT] (ENTER)
Determines an operation or item. (page 17)
Shows TV channel display. (page 18)
[MENU]
Shows the menu screen. (page 17)
[] [] (PRESET)
Selects the preset channel. (page 19)
Sets the preset channel writing/deleting mode. (page 19)
[] [] |
Press [] or [] to select “ON” or “OFF”.
Press [ENT] (ENTER) or [MENU] to set and return to the previous display.
Note:
Only English is displayed on the OSD screen.
16 |
|
| 17 | ||
|
|
|
|
|
|